NOTE: If you do not see the display model under your network tab, please reset the display by pressing and holding the RESET button for 10 seconds, located in the battery compartment of the display. If using a smartphone or tablet, you will need to access the Wi-Fi settings to view the list of available Wi-Fi networks. NOTE: The network tab is located in the bottom right corner of your computer screen on the taskbar, as shown below. Open the network tab and click on the AcuRite Wi-Fi Display Model Number.From a computer, (you can use a smartphone or tablet but this works best from a laptop or desktop computer), open an internet browser and type 192.168.4.1 in the URL - DO NOT PRESS ENTER.If you’re not sure, try the alternatives. Look carefully to differentiate “I”, "l", and “1”.Look carefully to differentiate “D”, "O", and “0”.
Look carefully to differentiate “3”, “B”, and “8”. Have these ready and keep in mind that these are also case sensitive. Once your station is created you will be provided with a Station ID and Station Key. Select the correct device hardware under Personal Weather Station then enter the requested information. Create an account on and Add New Device. Have your Wi-Fi network's SSID (name) and Password ready. If neither of these options are available, look for one that says something like WPA Personal. These products support the following security protocols on a 2.4 GHz network: WPA-TKIP, WPA2-AES-PassPhrase, WPA2-AES-PSK, Combo-WPA-TKIP, and Validation-OPEN. The weather station display is equipped with a Wi-Fi module that only supports 2.4 GHz wireless networks. Ensure your router is broadcasting a 2.4 GHz network. Most routers have DHCP enabled by default. Make sure DHCP is enabled on your router. Once the sensor is mounted, remove the rain gauge stabilizer from the sensor. 
Find a suitable place to mount the outdoor sensor. If applicable, please make sure that you have backup batteries installed. This feature is not available when only using backup batteries. Make sure that the display unit is plugged in with the included power adapter. Confirm the display is maintaining 4 bars of signal strength and is receiving current data. Pair the sensor and the display per the manual's instruction. Please follow the steps carefully as the order is crucial to the success of the Wi-Fi setup. If your display unit has the Wi-Fi capability to stream its data to Weather Underground, the following procedure can be used to set up this connection.
0 kommentar(er)
